ASeg Signal Pause Segmentation
The ASeg_Signal_Pause_Segmentation function automatically segments a signal using an RMS/level function.
parameter name
The name of the parameter to use for peak detection.
segment name
The base segment name for automatic name generation.
pause level type
Determines what value is used as the peak threshold.
automatic - pause level chosen automatically. cursor-ymax - y position of active cursor used as pause level. userdefined - use the user defined pause level.
percentage (Lxx)
pause level
The user defined pause level in dB. This is only available if pause level type is set to automatic.
signal on
A signal is detected if the level is greater than the pause level plus signal on.
signal off
A pause is detected if the level is less than the pause level plus signal off.
min. "on" time
The minimum duration the signal must be above the signal on level in order to be considered to be
max. "off" time
The maximum duration of a pause inside a segment (in seconds).
use whole analysis signal
If left unchecked, the signal between the cursors is analysed. If checked, the whole analysis signal is used.
